Allen-Bradley 1738-ADNX Instrukcja Użytkownika Pobierz pdf (Strona 53)

1 Publication 1738-UM001A-EN-P - February 2005

Chapter

Configure the DeviceNet Scanner Subnet

This chapter describes how to custom configure your scanner for use

with ArmorPoint I/O modules.

Your adapter works on two networks simultaneously and must be

configured for each separately. This chapter explains configuration of

the scanner for use with ArmorPoint I/O modules.

For information on how to configure the adapter for use on the

DeviceNet Network see Chapter 5, Adding the DeviceNet adapters to

the DeviceNet Scanner’s Scanlist.

Configuration Overview

You must use the RSNetWorx for DeviceNet software to configure

your scanner. You can configure the scanner while it is:

• on line

• off line

This chapter shows configuration in the offline mode. Configuration

screens appear the same in both modes. Note that some screen

options are unavailable in offline mode. The only difference is that if

you make changes off line, you must take the scanner on line before

the configuration changes take effect.

See the following sections: Page:

Configuration Overview 4-1

Add the Scanner To Your Network 4-2

Add I/O Modules To Your Network 4-3

Set the Scanner’s Parameters 4-3

Go On Line 4-8

Chapter Summary and What’s Next 4-8

IMPORTANT

Throughout most of this manual, we refer to the

ArmorPoint I/O DeviceNet adapter as the adapter.

The adapter also communicates with Subnet

modules as a scanner. In this chapter only, the

adapter is referred to as a scanner.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 133 134

Brak uwag

Allen-Bradley 1738-ADNX Instrukcja Użytkownika Strona 53